Dayton/Richmond B-18 Single Flared Coil Insert is made with the loop end flared for greater anchorage in the concrete. Standard lengths and sizes are shown in the chart. Special lengths and flare shapes can be special ordered.

Dayton/Richmond B-16 Coil Loop Insert Straight is made of a single looped wire strut welded to a helix coil. B-16 inserts are available in 1/2", 3/4" and 1" nominal diameter standard or screw-on coil and in various standard lengths. The B-16 is also available in other than standard lengths and with a nailing washer face on special order.

Dayton/Richmond B-17 Double Flared Coil Loop Insert is made with two looped wire struts welded to a helix coil.
The B-17 insert is suitable for heavy form anchorage in mass concrete construction. Standard length is 12" for 1", 1-1/4"
and 1-1/2" diameter units. Standard 6" nominal flares are supplied unless special size or shaped flares are requested.

Dayton/Richmond Expanded Coil Inserts are coil or closed ferrule structural connection inserts available in two, four or six strut versions, in 1/2" through 1-1/2" diameters, with or without nailing washer.

Dayton/Richmond F-42 Loop Ferrule Insert is a versatile insert suited for structural connections and suspension of equipment, ceilings, piping, etc. Available in 1/4" to 1" diameter closed ferrules in 1/8" increments.

Dayton/Richmond F-44 Thin Slab Ferrule Insert is used where the depth of embedment is limited. The F-44 is specially designed to develop good working loads in very thin concrete slabs. Available in 1/4" through 1" diameter, in 1/8" increments, closed ferrules.

Dayton/Richmond D-1-PA Anchor Bolts are manufactured with 1-1/2" of 1/2" diameter NC thread in 6", 8", 10", 12",
14", 16" and 18" standard lengths. The D-1-PA bolts are furnished with a 1/2" NC threaded nut and a cut washer. They are sold only in packages of 50 pieces.

Dayton/Richmond D-1-S Anchor Bolt Sleeve allows one size sleeve to accommodate two or more anchor bolt diameters. The unique high-density polyethylene plastic design provides flexibility and reduces inventory requirements.

If sizing is required, simply cut the sleeve at the gage line as shown.
Anchor Bolt Sleeves provide a grout pocket around the anchor bolt to allow the bolt to be positioned exactly. They provide a quick, easy way to make final adjustments and a clean pocket for grouting at lower cost than other methods.